Current shot 6/12/2010 in DHCP (main router mode)
Back in April 2010 when I had learned about this router after reading SNB review on it.
I had said, boy I must have this router well indeed such a wireless router made into a wired router giving you
Another testing will be coming up shortly. This will involve scoping the wireless from top to bottom and venturing outdoors in 360 degree radius and 250 feet distance ratio coverage. Wireless laptop or netbook will have on board Xrrius WiFi Inspector,
I noticed they have a GPL for it, any chance it will be supported by DD-WRT
I saw a new firmware that has a feature called turbo nat.
Is it stable ?
Ok from what i understand, it does have a bandwidth monitor but only in firmware 1.09
However even then it's not that great. I suggest Tippy, you ask Engenius to seriously consider adding the bandwith monitor back onto the newer firmwares and make it
I want to buy new router maybe two new ones but
don't know which one to get and or if two are even needed. My current
setup consists of belkin-n wireless router that is hooked up to my cable
modem and main pc in the basement this is the one that
Firmware 1.09
http://www.filefront.com/16514447/ESR9850-1-0-9-67.rar/
Well as I did mention prior I am back and since doing my Flush out the NVRAM before you Ref-flash your Router, which I did with the Russian firmware. I was able to downgrade to 1.21 and finally back to 1.11.
This time around I've slapped on triple 5dBi
Firmware 1.10
http://www.filefront.com/16820247/ESR9850-1-1-0-86.rar/
Pictured: above is ESR-9850 initial set-up as the main DHCP router and primary AP, along with Trendnet 16-port 10/100 Switch with 1.5MB Packet Buffer and Trendnet 8-port Copper Gig Green Switch with 144KB Packet Buffer. To the far left was a test going on
* Basic Features
- Android 2.2(Froyo) and Linux Kernel 2.6.32.9
- EXT4 file system for Android rootFS
- Faster than previous Eclair.
* What's New
- SDHC Card compatibility issue fix (Slightly lower voltage on SD card from 2.8V to 2.6V)
- HDMI
Got as far as the command screen. Typed in su and pressed return per instructions, got message stating program is requesting super user; then goes back to blue screen where $ sign is still there istead of #. Any response as to what went wrong? If I don't
There is a firmware update on the Coby USA web site. No info on what is in it or how to install.